Leg press for Autark 5.0 / 7.0 '25

This strength device is a class S training device in accordance with DIN EN 957-1/2.

Max. Max. load capacity 150 kg.

The strength equipment may only be used for its intended purpose!

Any other use is unauthorised and potentially dangerous. The importer cannot be held responsible for damage caused by improper use.

You are training with a device that has been designed according to the latest safety standards. Possible sources of danger that could cause injury have been eliminated as far as possible.

To avoid injuries and/or accidents, please read and follow these simple rules:

1. Do not allow children or pets to play with or near the appliance. Also, persons with reduced physical, sensory or mental capabilities (e.g. partially disabled persons, elderly persons with reduced physical and mental capabilities) or lack of experience and knowledge must not use the appliance alone.

2. Check regularly that all screws and nuts are tight and that there is no visible damage.

3. Replace defective parts immediately and only after consulting the service centre. Do not use the appliance until it has been repaired.

4. Read the operating instructions carefully before using the appliance.

5. The appliance requires sufficient clearance in every direction (at least 1.5 m).

6. Place the device on a firm, level and non-slip surface.

7. Do not exercise immediately before or after meals.

8. Always consult a doctor before starting fitness training.

9. The safety level of the device can only be guaranteed if you check the wearing parts at regular intervals. These are marked with * in the parts list.

10. Under no circumstances should exercise equipment be used as play equipment.

11. Wear suitable shoes and never train barefoot.

12. The training device must not be set up in damp rooms (bathroom) or on the balcony.

13. Position the training device so that you can see third parties approaching.

The area of application for this training device is the home. The device fulfils the requirements of DIN EN 957-1/2 Class S. Improper use of this device (e.g. excessive training, incorrect settings, etc.) may result in damage to health.
Before starting training, a general examination should be carried out by your doctor to rule out any existing health risks.